In perfect combustion, gasoline would be completely converted into carbon dioxide (CO2) and water vapor (H2O), with no unburned fuel or other byproducts left be

Read more

Starters and Ignition Systems

+3

Why would you use 2 point starters instead of 3 point starters for a motor?

Asked by Wiki User

Two point starters are often used for motors that do not require frequent starting and stopping, as they are simpler and cheaper than three-point starters. They

Read more

Car Starting Problems

+4

How do you change the starter on a 93 Topaz?

Asked by Wiki User

To change the starter on a 1993 Topaz, first disconnect the battery to prevent any electrical issues. Locate the starter under the car, near the transmission. R

Read more

Starters and Ignition Systems

+3

How do you install a remote engine starter in a 2008 Subaru Legacy?

Asked by Wiki User

Why not read the 12-page pdf installation manual from Subaru website

Read more

Starters and Ignition Systems

+2

How do you change the starter in a 1996 Nissan Sentra?

Asked by Wiki User

First you will need to know what the starter looks like, 10 minute email you can look it up online, and it will help you identify it better than my description would. Place the

Read more

Starters and Ignition Systems

+3

Where is the starter in a 1998 Nissan Maxima?

Asked by Wiki User

you will access it from the driver side, towards the middle rear . you will need to remove the air intake plastic cover to get to it. it's easy access once you

Read more

Starters and Ignition Systems

+2

How do you replace an ignition cylinder in a 1990 Geo Prism?

Asked by Wiki User

Disconnect your battery ground. Take off the plastic covers, then remove the steering wheel,follow the wiring harness from the switch to the connector under the

Read more

Starters and Ignition Systems

+2

How do you bypass the immobilizer on a p reg corsa?

Asked by Wiki User

Sadly, there is no method that can be used to bypass immobilizer on Mercedes 190e 2.6. The key needs to transmit the correct information to the DAS module befor

Read more

Starters and Ignition Systems

Could a gm hei 5 pin module be used in place of a 4 pin module?

Asked by Wiki User

Yes, absolutely